The quantum state vector of a single particle with total angular momentum quantum number j and total magnetic quantum number m = j, j − 1, ..., −j + 1, −j, is denoted as a ket |j, m⟩. As a diagram this is a singleheaded arrow.
Symmetrically, the corresponding bra is ⟨j, m|. In diagram form this is a doubleheaded arrow, pointing in the opposite direction to the ket.
In each case;
The most basic diagrams are for kets and bras:
Arrows are directed to or from vertices, a state transforming according to:
As a general rule, the arrows follow each other in the same sense. In the contrastandard representation, the time reversal operator, denoted here by T, is used. It is unitary, which means the Hermitian conjugate T† equals the inverse operator T−1, that is T† = T−1. Its action on the position operator leaves it invariant:
but the linear momentum operator becomes negative:
and the spin operator becomes negative:
Since the orbital angular momentum operator is L = x × p, this must also become negative:
and therefore the total angular momentum operator J = L + S becomes negative:
Acting on an eigenstate of angular momentum |j, m⟩, it can be shown that:1
The time-reversed diagrams for kets and bras are:
It is important to position the vertex correctly, as forward-time and reversed-time operators would become mixed up.
The inner product of two states |j1, m1⟩ and |j2, m2⟩ is:
and the diagrams are:
For summations over the inner product, also known in this context as a contraction (cf. tensor contraction):
it is conventional to denote the result as a closed circle labelled only by j, not m:
The outer product of two states |j1, m1⟩ and |j2, m2⟩ is an operator:
For summations over the outer product, also known in this context as a contraction (cf. tensor contraction):
where the result for T|j, m⟩ was used, and the fact that m takes the set of values given above. There is no difference between the forward-time and reversed-time states for the outer product contraction, so here they share the same diagram, represented as one line without direction, again labelled by j only and not m:
The tensor product ⊗ of n states |j1, m1⟩, |j2, m2⟩, ... |jn, mn⟩ is written
and in diagram form, each separate state leaves or enters a common vertex creating a "fan" of arrows - n lines attached to a single vertex.
Vertices in tensor products have signs (sometimes called "node signs"), to indicate the ordering of the tensor-multiplied states:
Signs are of course not required for just one state, diagrammatically one arrow at a vertex. Sometimes curved arrows with the signs are included to show explicitly the sense of tensor multiplication, but usually just the sign is shown with the arrows left out.
For the inner product of two tensor product states:
there are n lots of inner product arrows:
P.E.S. Wormer; J. Paldus (2006). "Angular Momentum Diagrams". Advances in Quantum Chemistry. 51. Elsevier: 59–124. Bibcode:2006AdQC...51...59W. doi:10.1016/S0065-3276(06)51002-0. ISBN 9780120348510. ISSN 0065-3276. These authors use the theta variant ϑ for the time reversal operator, here we use T. 9780120348510 ↩