Spray drying

Spray drying is a method of forming a dry powder from a liquid or slurry by rapidly drying with a hot gas. This is the preferred method of drying of many thermally-sensitive materials such as foods and <a href="/facts/Pharmaceuticals/h9mhwWP2">pharmaceuticals</a>, or materials which may require extremely consistent, fine particle size. Air is most commonly used as the heated drying medium; however, <a href="/facts/Nitrogen/Nf1QpGDz">nitrogen</a> may be used if the liquid is flammable (such as <a href="/facts/Ethanol/3lCLfBSP">ethanol</a>) or if the product is oxygen-sensitive.
All spray dryers use some type of <a href="/facts/Atomizer_nozzle/BIDHsj01">atomizer</a> or <a href="/facts/Spray_nozzle/xlvwoAoM">spray nozzle</a> to disperse the liquid or slurry into a controlled drop size spray. The most common of these are rotary disk and single-fluid high pressure swirl nozzles. Atomizer wheels are known to provide broader particle size distribution, but both methods allow for consistent distribution of particle size. Alternatively, for some applications two-fluid or <a href="/facts/Ultrasonic_nozzle/cLrLr966">ultrasonic nozzles</a> are used. Depending on the process requirements, drop sizes from 10 to 500 μm can be achieved with the appropriate choices. The most common applications are in the 100 to 200 μm diameter range. The dry powder is often free-flowing.
The most common type of spray dryers are called single effect. There is a single source of drying air at the top of the chamber (see n°4 on the diagram). In most cases the air is blown in the same direction as the sprayed liquid (co-current). A fine powder is produced, but it can have poor flowability and causes a lot of dust. To overcome the dust issues and poor flowability of the powder, a new generation of spray dryers called multiple effect spray dryers have been developed. Instead of drying the liquid in one stage, drying is done through two steps: the first at the top (as per single effect) and the second with an integrated static bed at the bottom of the chamber. The bed provides a humid environment which causes smaller particles to clump, producing more uniform particle sizes, usually within the range of 100 to 300 μm. These powders are free-flowing due to the larger particle size.
The fine powders generated by the first stage drying can be recycled in continuous flow either at the top of the chamber (around the sprayed liquid) or at the bottom, inside the integrated <a href="/facts/Fluidized_bed/gJETYPNR">fluidized bed</a>.
The drying of the powder can be finalized on an external vibrating fluidized bed.
The hot drying gas can be passed in as a co-current, same direction as sprayed liquid atomizer, or counter-current, where the hot air flows against the flow from the atomizer. With co-current flow, particles spend less time in the system and the particle separator (typically a cyclone device). With counter-current flow, particles spend more time in the system and is usually paired with a fluidized bed system. Co-current flow generally allows the system to operate more efficiently.
Alternatives to spray dryers are:

<ol><li><a href="/facts/Freeze-drying/aURqwbrQ">Freeze dryer</a>: a more-expensive batch process for products that degrade in spray drying. Dry product is not free-flowing.</li>
<li><a href="/facts/Drum_drying/XSzF6jX3">Drum dryer</a>: a less-expensive continuous process for low-value products; creates flakes instead of free-flowing powder.</li>
<li>Pulse combustion dryer: A less-expensive continuous process that can handle higher viscosities and solids loading than a spray dryer, and sometimes yields a freeze-dry quality powder that is free-flowing.</li></ol>

Spray drying open-in-new

Spray drying