Bus and Tag

Bus and Tag is an IBM standard for a computer peripheral interface, and was commonly used to connect their mainframe computers to peripheral devices such as <a href="/facts/Line_printer/QyWwtNBJ">line printers</a>, <a href="/facts/Disk_storage/hnsXRb5X">disk storage</a>, <a href="/facts/Magnetic_tape_data_storage/qJUpJnk9">magnetic tape drives</a> and <a href="/facts/IBM_3270/QKeJWI7t">IBM 3270</a> display controllers. The technology uses two sets of thick, multi-connector copper cables, one set, carrying data, called the bus, and the other set, carrying control information, called the tag.

Bus and Tag cables are <a href="/facts/Daisy_chain_(electrical_engineering)/x1FsIB1E">daisy chained</a>; and one interface can attach up to eight peripheral control units. The last control unit in the chain must have a terminator plug. Each control unit can attach a particular maximum number of devices, sixteen being typical. There is an architectural limit of 256 devices per channel, and initially a limitation of 200 feet (61 m), later extended to 400 feet (120 m), between the mainframe and the control unit. Bus and Tag channels handle data rates up to 4.5 MB per second. Only one device can transfer data at a time.
Bus and Tag architecture was also used by other computer manufacturers to attach IBM peripherals to their systems. It was later published by the US <a href="/facts/National_Technical_Information_Service/tTdsJFnq">National Technical Information Service</a> (NTIS) as FIPS PUB 60-2, I/O Channel Interface.
Bus and Tag was introduced with <a href="/facts/System%2f360/7znvpy4K">System/360</a> in 1964, and was also used with <a href="/facts/System%2f370/TRo1jaFw">System/370</a>. With the introduction of <a href="/facts/Serial_communication/r5xP7P1c">serial</a>, <a href="/facts/Fiber_optic/5ruuIFbj">fiber optic</a> <a href="/facts/ESCON/oYh25l0t">ESCON</a> in the 1990s Bus and Tag channels were re-christened "parallel channels", and were gradually superseded. Parallel channels are not available on newer mainframes (as of 2018) and are slowly being displaced on older systems. Equipment is available to allow connection of older devices using Bus and Tag to mainframe <a href="/facts/FICON/sX4NCdzH">FICON</a> or ESCON channels.

Bus and Tag open-in-new

Bus and Tag